The K+ Intake System allows you to unlock the full potential of the 2.0 FSI-T Engine by replacing the very restrictive plastic factory air box. The K+’s intake system allows the engine to suck in much more fresh air, lets your engine breath the way it should at the first place and ultimately get much better performance. The intake piping of the K+ Intake System was designed to generate the best air flow to the engine; the diameter was measured to give the best throttle response and faster turbo spool. At the location of the Mass Airflow Sensor, the K+ System is uses a 3 inch piping (see pics below) to trick the sensor so that it thinks there is enough mass and air inside, therefore the car will run a lot smoother. All the other sections are 2.5 inch to give the best throttle response. The piping is made out of mandrel bend aluminum which is lightweight and dissipates heat much better then any other material.
The Intake is section is made of thick Interlocking Cell Polyurethane Foam which traps the tinniest particles, is also very easyto clean and maintain.
With the K+ Intake System installed you will not lose low end performance and also get amazing high end. Please refer to Dyno Sheet to actual results, an amazing 25.9 HP & 26.4 ft/lb at the flywheel!!
Here is the dyno results done a Dynapack which reads HUB horsepower, it gives different readings from a dynojet.
No comments:
Post a Comment